Removal and installation of an external mirror Mirror replacement
Removal
|
|
Disconnect a negative cable (-) the storage battery.
|
|
|
Open a door and take out a triangular overlay from three holders of clips. Thus an overlay at first disconnect below.
|
Turn out the screw (7) and remove a mirror with the block of adjustment (2) from a door (5).
|
|
Disunite a socket (6). (3) – the bottom cover.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal. Thus watch correct position of consolidation (8) at the basis of a mirror (9). Tighten the screw (7) moment 12Нм.
Tighten consolidation at a window frame over a triangular overlay.
Attach a negative cable (-) the storage battery.
|
|
Replacement of glass of a mirror
Removal
|
|
Disconnect a negative cable (-) the storage battery.
|
|
|
Paste over the case of a mirror with a tape above and below to protect it from damage.
|
|
Cautiously hook a plastic wedge mirror glass at first below, and then above.
|
Take out glass from the case and disunite a socket of heating of a mirror.
|
|
Installation
Operation of lifting and car installation on supports is connected with danger! Therefore before operation carrying out familiarise with Razdelom Poddomkrachivanie and towage.
|
|
Establish glass of a mirror (4) on a basic plate (2) and join a socket of heating of a mirror.
|
|
Insert glass into directing pins and displace a finger (3) in a frictional spring (marksman).
|
Fix glass, thus press only in the glass centre. (1) – the mirror case.
|
Attach a negative cable (-) the storage battery.
|
|
|
|
Replacement of the case of a mirror
Removal
|
|
Remove mirror glass, address to corresponding Section.
|
Turn out screws (4), disconnect the bottom cover (3) of holders and remove downwards.
|
|
Disconnect the case of an external mirror (1) of holders (arrow) and remove upward.
|
|
Installation
|
|
Establish the case of an external mirror from above on the block of adjustment (2).
Fix the case above and below on the block of adjustment (2). Thus holders of the block of adjustment should enter into lock hooks of the case.
Insert from below a cover (3), fix and fix.
Establish to the place of mirror glass.
|
|
|
