Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
Suspension bracket and steering
- Body
The general data and security measures at carrying out кузовных works
Cleaning and leaving
Repair of insignificant damages кузовных panels
Repair of considerable damages of a body
The external equipment
- The salon equipment
Remarks on work with the salon and security measure equipment
Removal and installation of spring clips
Removal and installation of the central console
Removal and installation of the holder of drinks
Removal and installation of facing of the lever of a lay brake
Removal and installation of a cover of the lever of switching of transfers/selectors
Removal and ashtray installation
Removal and installation of the central armrest
Removal and installation of an internal mirror
Removal and cover installation on a control panel
Removal and pocket installation from outside the driver
Removal and installation of a ware box
Removal and installation противосолнечного a peak
Removal and installation of facing of a rack And
Removal and installation of the top facing of a rack In
Removal and installation of the bottom facing of a rack In
Removal and installation of a forward overlay of a threshold
Removal and installation of facings (Sedan)
Removal and installation of facings (Versatile person)
Removal and installation of a forward seat
Removal and installation of a back seat
Removal and installation of a forward seat belt
Removal and installation of a back seat belt
Onboard electric equipment
|
Removal and installation of facings (Sedan) Rack With
Removal
|
|
|
|
At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures. |
|
To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Instructions are resulted in Section Replacement of the storage battery.
Remove closing lath of a roof, see more low.
|
Turn out screws (2).
|
|
Remove lateral pillows of a back seat, address to Section Removal and installation of a back seat.
Take out a clip (3) under a lateral pillow.
Disconnect a lateral shelf and raise it, address to corresponding Section.
Disconnect facing of a rack With (1) at a spring clip (4) and remove it.
|
|
Installation
|
|
Raise a shelf and insert facing of a rack With into grooves on a regiment.
The further installation is carried out in sequence, return to removal. Thus replace self-stopped screws (2) with the new.
|
|
During joining of the storage battery in salon there should not be people. |
Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (), and then a negative cable (-) to a battery accumulator room.
|
|
Rack D
Removal
|
|
|
|
At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures. |
|
To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Instructions are resulted in Section Replacement of the storage battery.
Remove facing of rack D, address to corresponding Section.
|
Press downwards the handle (5) and cast away downwards a cover of the screw (4). For this purpose enter into a groove (7) thin wire and open a cover.
|
|
Turn out screws (6).
Turn out the screw (3) and disconnect behind facing of a rack And, address to corresponding Section.
Extend facing (1) under facing of a rack of Century
Disconnect facing of rack D (1) at spring clips (2) and extend from a shelf.
|
|
Installation
|
|
Enter into a shelf facing behind rack D.
Insert a hook (7) in шлиц at facing of a rack With.
Fix facing of rack D at spring clips (2).
Insert forward facing under facing of a rack of Century
Check up, that the clip and a hook of the adapter of a pillow of safety have been reliably fixed.
Screw the screw (3) and fix facing behind a rack And.
Fix the handle new self-stopped screws (6). Put into place a screw cover.
Put over facing a door sealant.
Establish into place a lath of the lock of a roof, see more low.
|
|
During joining of the storage battery in salon there should not be people. |
Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (), and then a negative cable (-) to a battery accumulator room.
|
|
Closing lath of a roof
Removal
|
|
Disconnect closing lath of a roof (1) at spring clips (2) of grooves (3) and remove.
|
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
|
|
Back entrance lath
Removal
Installation
|
|
Installation is carried out in sequence, return to removal.
|
|
Shelf
Removal
|
|
Depending on the equipment: Cast away a back of a back seat or remove, address to Section Removal and installation of a back seat.
Disconnect from a shelf facing of a rack With at the left and on the right.
Remove the left and right lateral pillows of a back seat, address to Section Removal and installation of a back seat.
Not leaning back back seat: Disconnect below the central seat belt.
|
Remove from a shelf by means of a plastic wedge a lattice of a loudspeaker (3).
|
|
Depending on the equipment turn out 3 or 4 screws (4).
Turn out from below 3 screws of fastening solar шторок in a luggage carrier and extend a curtain forward.
Pull a shelf (1) forward (marksman), disconnect at an edge (2) and take out upward.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
|
|
Lateral facing of a luggage carrier
Removal
|
|
Open a luggage carrier and take out a floor cover.
Remove facing of overlapping of a back.
Remove a back of a back seat, address to Section Removal and installation of a back seat.
Turn out bolts of fastening of eyes of a luggage carrier.
Disconnect lateral facing at four spring clips above and behind and remove upwards. If it is necessary, preliminary open in facing a cover sidewallsы.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal. Thus a door sealant put over facing.
|
|
Back overlapping
Removal
|
|
Open a luggage carrier and take out a floor cover.
|
Turn away 2 nuts (2), if necessary, take out a spare wheel.
|
|
Disunite a socket of a lamp of illumination of a luggage carrier.
Disconnect facing of overlapping of a back (1) in four spring clips (3) and remove overlapping.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
|
|
|
|
