Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
Suspension bracket and steering
- Body
The general data and security measures at carrying out кузовных works
Cleaning and leaving
Repair of insignificant damages кузовных panels
Repair of considerable damages of a body
The external equipment
- The salon equipment
Remarks on work with the salon and security measure equipment
Removal and installation of spring clips
Removal and installation of the central console
Removal and installation of the holder of drinks
Removal and installation of facing of the lever of a lay brake
Removal and installation of a cover of the lever of switching of transfers/selectors
Removal and ashtray installation
Removal and installation of the central armrest
Removal and installation of an internal mirror
Removal and cover installation on a control panel
Removal and pocket installation from outside the driver
Removal and installation of a ware box
Removal and installation противосолнечного a peak
Removal and installation of facing of a rack And
Removal and installation of the top facing of a rack In
Removal and installation of the bottom facing of a rack In
Removal and installation of a forward overlay of a threshold
Removal and installation of facings (Sedan)
Removal and installation of facings (Versatile person)
Removal and installation of a forward seat
Removal and installation of a back seat
Removal and installation of a forward seat belt
Removal and installation of a back seat belt
Onboard electric equipment
|
Removal and installation of facings (Versatile person) Rack With
Removal
|
|
|
|
At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures. |
|
To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Instructions are resulted in Section Replacement of the storage battery.
Remove a lateral pillow of a back seat, address to Section Removal and installation of a back seat.
Remove lateral facing of a luggage carrier, address to corresponding Section.
Remove facing over a back door.
Ослабьте screws of fastening of a pillow of safety of a head in a back part.
Remove directing for a back belt, address to Section Removal and installation of a back seat belt.
|
Turn out screws (3), disconnect facing (1) at a spring clip (2) and remove.
|
|
|
Installation
|
|
Installation is carried out in sequence, return to removal. Thus fix a pillow of safety of a head new screws.
Put a door sealant over facing.
|
|
During joining of the storage battery in salon there should not be people. |
Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (), and then a negative cable (-) to a battery accumulator room.
|
|
Facing over a back door
Removal
|
|
|
|
At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures. |
|
To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Instructions are resulted in Section Replacement of the storage battery.
Disconnect facing behind a rack And.
Remove facing of rack D.
|
Press downwards the handle (5) and cast away downwards a cover of the screw (4). For this purpose enter into a groove (7) thin wire and open a cover.
|
|
Turn out screws (3).
Turn out the screw (1).
Turn out the screw (7) for what displace back a lath in an eye for a dividing grid.
Disconnect facing (2) at a spring clip (6) and remove.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal, thus the screw (7) tighten the moment 9Нм.
|
|
During joining of the storage battery in salon there should not be people. |
Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (), and then a negative cable (-) to a battery accumulator room.
|
|
Rack D
Removal
|
|
|
|
At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures. |
|
To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Instructions are resulted in Section Replacement of the storage battery.
Remove closing lath of a roof, address to Section Removal and installation of facings (Sedan).
Disconnect a back edge of lateral facing of a cargo compartment, address to corresponding Section.
|
Turn out the screw (3) for what displace back a lath in an eye for a dividing grid.
|
|
Disconnect facing (1) at two spring clips (2) and take out upwards from lateral facing of a cargo compartment.
Take out facing of rack D (1) back from facing (4) over a door.
Ослабьте in a back part screws of fastening of a pillow of safety of a head.
Turn out screws (6) and remove facing (5) over a back window.
|
|
Installation
|
|
Installation is carried out in sequence. Return to removal. Thus fix a pillow of safety of a head new screws.
Put a sealant of a cover of a back over facing.
|
|
During joining of the storage battery in salon there should not be people. |
Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (), and then a negative cable (-) to a battery accumulator room.
|
|
Closing lath of a roof
Removal
|
|
Disconnect closing lath of a roof (1) at four spring clips (2) and remove.
|
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
Put a sealant of a cover of a back over a closing lath of a roof.
|
|
Lateral facing of a cargo compartment
Removal
|
|
Lateral facing right: Disconnect a negative cable (-) the storage battery.
|
|
|
Remove a lateral pillow of a back seat, address to Section Removal and installation of a back seat.
Release a floor of a cargo premise and take out.
Remove an overlay of a cargo compartment, see more low.
|
Turn out screws (4) fastenings of an eye for luggage (5).
|
|
Turn out the screw (3) and disconnect lateral facing (2) at spring clips (1).
The right lateral facing: Disunite a socket socket.
Take out lateral facing.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
The right lateral facing: Attach a negative cable (-) the storage battery.
|
|
Overlay of the lock of a cargo compartment
Removal
|
|
Open a back door.
|
Turn out 4 screws (1) and cautiously disconnect an overlay of the lock (2) from an edge of a compartment at lock fingers (the marksman on an accompanying illustration). Thus displace a plastic wedge under an overlay and each finger remove separately.
|
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
|
|
|
|
