Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
- Suspension bracket and steering
   Security measures at work
    Suspension bracket of forward wheels
   - Suspension bracket of back wheels
      The general data
      Removal and installation of a screw spring
      Removal and shock-absorber installation
    Corners of installation of wheels of the car
    Steering and safety pillows
Body
Onboard electric equipment



Черные точки на лице причины и как убрать

Removal and shock-absorber installation

The shock-absorber

1 — the Nut, 25Нм, self-stopped, necessarily replace
2 — a shock-absorber Support
3 — the Buffer of a course of compression
4 — the Protective casing
5 — the Shock-absorber, pay attention to distinction performed by a running gear

Removal

The special tool is necessary for shock-absorber removal. HUNDRED AUDI apply to this purpose the adaptation for compression V.A.G.1752/1, adapter V.A.G. 1752/9 and the holder of spring V.A.G. 1752/16.

 PERFORMANCE ORDER

    Mark with an arrow on the tyre a direction of rotation of a wheel. Ослабьте bolts of fastening of a wheel. Lift and establish on supports a back part of the car and remove a wheel. Remove a spring, address to Section Removal and installation of a screw spring.
    Turn away a nut (1) and take out a bolt (on an accompanying illustration the guard is not shown).
    Turn out a bolt (2).

The wheel casing does not act in film.

    Take out the shock-absorber.
    At отворачивании and an inhaling of nuts of fastening of a support of the shock-absorber keep from проворачивания a rod. HUNDRED AUDI apply for this purpose the special tool 3017А.

Installation

 PERFORMANCE ORDER

    Establish a support on the shock-absorber and fix its new self-stopped nut the moment 25Нм.
    Tighten bolts (2) moment 36Нм. Watch position of the bottom fastening. At first tighten a nut of the bottom fastening of the shock-absorber (1) moment 30Нм.
    Establish into place a spring, address to corresponding Section. Observing a direction of rotation of a wheel, fix a back wheel, lower the car on wheels and only after that tighten bolts of fastening of a wheel the moment 120Нм.

The inhaling of a nut of the bottom fastening of the shock-absorber is necessary for making as follows:

 PERFORMANCE ORDER

    Lower the car on wheels. Ослабьте the bottom fastening of the shock-absorber. Some times press through a car suspension bracket. Tighten a new nut (1) moment 150Нм and then tighten on a corner 90 .