Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
- The engine
   Specifications
   Removal and installation of the top cover of the engine / the bottom protection of an impellent compartment/stretcher
   Compression check in engine cylinders, revealing of leaks
   Check of the engine by means of the vacuum gauge
    4-cylinder petrol engines
   - 6 and 8-cylinder petrol engines
      The basic data
      Replacement of a gear belt of drive ГРМ
      Removal and installation of a head of the block of cylinders
      Removal and installation of a belt of a drive of auxiliary units
    4-cylinder diesel engines
    6-cylinder diesel engines
    System of greasing of the engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
Suspension bracket and steering
Body
Onboard electric equipment




Removal and installation of a belt of a drive of auxiliary units

Elements of a drive of auxiliary units. The 6-cylinder petrol engine

1 — Klinovoj a belt
2 — the Bolt, 23Нм
3 — the Generator
4 — the Bolt, 45Нм
5 — the Bolt, 23Нм
6 — the Holder of the generator
7 — the Screw, 40Нм
8 — the tension Device
9 — the Screw, 23Нм
10 — the Pulley of the pump of the hydraulic booster
11 — the Sealing ring. Necessarily replace
12 — the Hollow bolt, 47Нм
13 — the Pressure head pipeline for the pump of the hydraulic booster of a wheel
14 — the Pump of the hydraulic booster of a wheel

15 — the Holder of the pump
16 — the Bolt, 23Нм
17 — the Bolt, 23Нм
18 — the Holder of the compressor of the conditioner
19 — the Bolt, 23Нм
20 — the Nut, 23Нм
21 — the Bolt, 25Нм
22 — the Compressor. Attention: Pipelines of a cooling liquid do not turn on/disconnect. After removal the compressor fix a wire on a body. Do not suspend it for pipelines
23 — compressor Plugs
24 — the Pulley of a cranked shaft (демпфер крутильных fluctuations)
Depending on a year of release with a persistent washer or without it between демпфером крутильных fluctuations (a pulley of a cranked shaft) and a wheel of a gear belt.
25 — the Bolt, 23Нм
26 — the Bolt, 23Нм

The lining scheme the remnja.6-cylinder petrol engine

1 — the Generator
2 — Klinovoj a belt
3 — the Pump of the hydraulic booster of a wheel

4 — the Compressor
5 — the Cranked shaft
6 — the Tension roller

Removal

 PERFORMANCE ORDER

    Remove all top covers of the engine. Disconnect the electromagnetic valve of an adsorber of the fulfilled gases and remove a forward right air line. Mark with a chalk or a felt-tip pen a rotation direction on клиновом a belt.

Change of a direction of rotation of the belt which was in work, can lead to its rupture.

    Ослабьте wedge a belt also remove it. For this purpose incline the tension device the suitable lever, for example, 3299/3299/1 in a rotation direction.

Installation

 PERFORMANCE ORDER

    Installation is carried out in sequence, the return to removal. Thus at first put on wedge a belt a pulley of a cranked shaft and then on a tension roller.