Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
- Systems of cooling, heating and the air conditioner
Cooling system
- Systems of ventilation, heating and air conditioning
The general information and security measures
Removal and installation of the air snuffled
Removal and installation of the electric motor of a drive ventilating заслонки
Removal and installation of the block of management by a heater/conditioner
Removal and installation of the electric motor of a drive of the fan of a heater and the conditioner
Removal and installation of the gauge of temperature of external air
Removal and installation of an additional heating element
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
|
Removal and installation of the electric motor of a drive of the fan of a heater and the conditioner
|
|
The block of management of the fan of fresh air is established on the electric motor and can act in film and be replaced only together with the electric motor. |
Removal
|
|
Disconnect a negative cable (-) the storage battery.
|
|
|
Remove a ware box, address to Section Removal and installation of a ware box.
|
Disunite a socket ().
|
|
Release a cable connector ().
Remove facing on a rack And, address to Section Removal and installation of facing of a rack And.
Cautiously cast away a rug around an arrangement of feet.
|
Take aside шумозащитный a floor-mat and turn out the screw ().
|
|
Take aside шумозащитный a floor-mat and take out from a heater the fan (D) with the built in block of management.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
At installation pay attention to correct position of the fan in a heater.
Fix a cable a connector.
|
|
|
|