Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
- Systems of an electric equipment of the engine
Ignition and engine management system
System of preheat of the diesel engine
Diagnostics of systems of electronic control and the diagnostic equipment
- Gymnastics and start systems
The general information
The storage battery - the basic data and acquisition of the new battery
Check and gymnastics of the storage battery
Replacement of the storage battery
Storage of the storage battery
Gymnastics system - the general data and security measures
Check of system of gymnastics
Removal and generator installation
Removal and installation of a regulator of pressure/replacement of brushes
System of start of the engine - the general information and safety measures
Removal and starter installation
Check of system of start of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
|
Removal and installation of a regulator of pressure/replacement of brushes Removal
|
|
Remove the generator, address to corresponding section.
|
|
|
Depending on model regulator removal probably also on the established generator. |
|
Turn away a nut on connecting plugs.
Turn out screws and remove a protective cover from the generator.
|
|
|
Depending on model generators of various executions can be established. |
|
Turn out screws and take out a regulator aside.
Replace brushes, for what отпаяйте a rope.
Check up deterioration of rings, if necessary pierce them and polish (work HUNDRED).
|
|
|
Installation
|
|
Insert new brushes () and springs () in щёткодержатель () and solder contacts.
|
|
To exclude solder hit in a rope at a ration, clamp a rope of a brush flat-nose pliers.
|
|
|
At hit of solder ropes become rigid and brushes unsuitable for work. |
|
Establish into place a regulator of pressure and fix it.
After installation of new brushes check up them on ease of a course.
Fix on the generator a protective cover.
Screw nuts on connecting plugs.
Establish into place the generator, address to Section Removal and generator installation.
|
|
|
|
