Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
- Coupling, power shafts and differential
   - Coupling
      The general data
      Removal, installation and coupling check
      Removal and bearing installation
      Removal of air from hydrosystem of a drive of coupling
    Power shafts of wheels
    Models with a full drive of wheels
Brake system
Suspension bracket and steering
Body
Onboard electric equipment




Removal and bearing installation

The bearing of deenergizing of coupling

1 — A CHECK POINT
2 — the Spherical pin. Grease with greasing MoS 2. The tightening moment at a check point from an aluminium alloy: 25Нм; at a check point from a magnesian alloy: 18Нм.
3 — the Intermediate element
4 — Tarelchataja a spring. Smaller diameter is turned to directing plug
5 — the Sealing ring
6 — the Cuff of a primary shaft. Press against the stop
7 — Directing втулка*
8 — the Lock spring
9 — the Lever of the bearing of deenergizing of coupling. Before installation a pusher grease with copper greasing Z 381 351 TE

10 — the Screw with internal Torx*. Necessarily replace Black for a check point from the aluminium alloy, shining for a check point of a magnesian alloy. The moment of a tightening for a check point from an aluminium alloy: 35Нм; the moment of a tightening for a check point from a magnesian alloy: 25Нм.
11 — the Bearing of deenergizing of coupling. Do not wash out, only wipe
12 — the Bolt, 20Нм
13 — the Working cylinder of hydrosystem of a drive of coupling. At installation press the cylinder so that it was possible to enter a bolt easily
14 — the Pusher. Grease the end with copper greasing