Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
- Suspension bracket and steering
Security measures at work
Suspension bracket of forward wheels
Suspension bracket of back wheels
Corners of installation of wheels of the car
- Steering and safety pillows
The general data and security measures
Removal and installation of the block of a pillow of safety
Removal and steering wheel installation
Removal and installation of a tip of steering draught
Removal and installation of a protective cover of the steering mechanism
Body
Onboard electric equipment
|
Removal and installation of a tip of steering draught Removal
|
|
Mark on the tyre a direction of its rotation. Turn away bolts of fastening of a wheel. Lift and establish on supports a forward part of the car and remove a wheel.
|
Turn out a bolt (1).
|
|
Turn away a nut (5) and turn out a bolt (2).
|
|
|
Do not expand шлиц in the case of the bearing of a wheel with a chisel or any other similar tool. |
|
|
Do not apply a chisel or any similar tool to removal of steering draught by забивания it between the pendular lever (1) and a sealing washer (2) tips of steering draught. Steering draught can act in film only by выпрессовки the end of a pin of a tip from the steering lever or blows of a wooden or rubber hammer. |
|
Remove steering draught downwards.
|
|
Turn away a counternut (3) and turn out a tip from steering draught.
|
Wipe a tip of steering draught and клеммное an aperture on the case of the bearing of a wheel.
|
|
Installation
|
|
Screw a tip on steering draught against the stop.
Tighten a counternut (3) moment 40Нм. HUNDRED AUDI apply for this purpose tool V.A.G 1332/12. At an inhaling keep steering draught from проворачивания for шестигранник (4).
Expose steering draught so that the tip pin was in installation position.
|
Insert steering draught against the stop into the pendular lever.
|
|
|
|
Steering draught insert into the pendular lever (1) only by hand, thus do not press strongly on a sealing washer (2) tips. |
|
Insert a bolt (2) and screw a new nut (5), tighten a nut the moment 50Нм.
|
|
Establish a bolt (1) and tighten its moment 7Нм.
|
Establish and fix a wheel, observing a direction of its rotation. Lower the car and only after that tighten bolts cross-wise the moment 120Нм.
Spend measurements of a running gear of the car (work HUNDRED).
|
|
|
|