Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
- Manual box of a gear change
Specifications
Removal and check point installation
Check of level of oil in a manual check point
Adjustment of a drive of a gear change
Check of adjustment of the lever of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
Suspension bracket and steering
Body
Onboard electric equipment
|
Check of level of oil in a manual check point
|
|
Establish the car on an equal platform.
Lift and establish the car on a platform.
|
Turn out a stopper for filling with oil depending on execution by a face key on 10 mm, for example, HAZET 985-10 or a face key under a polyhedron, for example, AUDI-3357 or HAZET 2567-16. The stopper is located at the left on a check point under the gauge of a measuring instrument of speed and can be closed теплоозащитным the power shaft screen.
|
|
Check up level of oil by means of a wire bent at an angle. Oil level should be on 7 mm below the bottom edge of an aperture for заливания oils.
|
|
Filling also to level of the bottom edge of an aperture is supposed. Apply only synthetic oil specified in Specifications. |
Tighten a stopper the moment 25Нм.
|
|
Stopper different for a check point from aluminium and magnesian alloys. |
|
|
|
|