Uncover the lever of switching and the lever handle, address to Section Removal and installation of a cover of the lever of switching of transfers/selectors.
|
Pull an overlay (1) at first in an arrow direction () and then take out in an arrow direction ().
|
|
|
|
At cars with the control panel of the conditioner located over an ashtray, it is necessary to extend the panel preliminary a little. |
|
Turn out fastening bolts () and take out an ashtray (2) of the central console.
|
Take out upwards демпфирующую a washer (1) and демпфер noise (2).
|
|
Turn out bolts of fastening of a cover (an arrow on an accompanying illustration).
|
|
Measure distance () between two carving fingers in a switching drive.
|
|
|
|
It is necessary to measure centre to centre fingers. |
|
The distance should be and = 85 mm. If the received value differs from specified, adjust distance () as follows: Ослабьте the screw (arrow) of fastening of a pushing bar. The pushing bar should move easily in both parties behind in a switching drive on ползуне.
|
Adjust the size () by displacement of a pushing bar behind. Tighten a bolt of fastening of a pushing bar the moment 25Нм.
|
Ослабьте a bolt (an arrow on an accompanying illustration) in a switching drive. Connection a pushing bar/drive of switching should have an easy course.
|
|
Establish the switching lever: the Lever should be centered below in a spherical support. The distance from a spherical support to the switching lever below from different directions should be identical.
|
|
Establish the lever vertically in a direction of movement and keep it in this position.
|
Tighten a bolt of fastening of a bar of switching by the moment 25Нм.
|
|
Tighten bolts of fastening of a cover of protection against noise by the moment 10Нм. Watch installation position: the Arrow on a cover specifies in a direction "forward".
|
|
The button of inclusion with the fixing mechanism: Establish the button together with a cover of the lever of switching on the lever and turn a connecting element against the stop.
The button of inclusion with a tightening collar: Establish the inclusion button сновым a collar on the lever of switching and squeeze a collar flat-nose pliers.
If necessary, establish the block of management of the conditioner and an ashtray.
|