Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
Suspension bracket and steering
- Body
The general data and security measures at carrying out кузовных works
Cleaning and leaving
Repair of insignificant damages кузовных panels
Repair of considerable damages of a body
The external equipment
- The salon equipment
Remarks on work with the salon and security measure equipment
Removal and installation of spring clips
Removal and installation of the central console
Removal and installation of the holder of drinks
Removal and installation of facing of the lever of a lay brake
Removal and installation of a cover of the lever of switching of transfers/selectors
Removal and ashtray installation
Removal and installation of the central armrest
Removal and installation of an internal mirror
Removal and cover installation on a control panel
Removal and pocket installation from outside the driver
Removal and installation of a ware box
Removal and installation противосолнечного a peak
Removal and installation of facing of a rack And
Removal and installation of the top facing of a rack In
Removal and installation of the bottom facing of a rack In
Removal and installation of a forward overlay of a threshold
Removal and installation of facings (Sedan)
Removal and installation of facings (Versatile person)
Removal and installation of a forward seat
Removal and installation of a back seat
Removal and installation of a forward seat belt
Removal and installation of a back seat belt
Onboard electric equipment
|
Removal and installation of a back seat Back seat
Removal
|
|
Strong jerk disconnect a seat (arrow) from holders (1), raise it and pull back (an arrow In on an accompanying illustration).
|
|
Take out the tip of a lateral pillow of safety from a groove at a back wall of a pillow of a back seat remove a seat.
|
|
Installation
|
|
Establish a seat into place and insert the tip of a lateral pillow of safety into a groove in a pillow of a back seat.
Shift a seat back, in front press in holders (1) and fix.
|
|
Thus do not damage holders. |
|
|
Back of a back seat, folding
Removal
|
|
Cast away forward a back of a back seat.
|
Hook and remove behind a cover (3) (an arrow on an accompanying illustration). Turn out the screw (1) and remove a safety collar (2).
|
|
Lift a back (5) of a support (4) and remove from a lateral element of fastening (6). The plug (7), if necessary, again put on.
|
Uncover (2) at an armrest (1) in an arrow direction.
|
|
Turn out the screw (3).
Take out a finger (4) of a loop (5) and take out an armrest.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
|
|
Back of a back seat, motionless
Removal
|
|
|
|
At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures. |
|
Remove a back seat.
Take out headrests from backs.
Take out directing for headrests from backs. Thus insert a small screw-driver obliquely through an aperture at directing, press a screw-driver inside, release a stopper and take out directing of a back.
If necessary, take out from a back a framework of a bag for skis.
Models with a lateral pillow of safety: to exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive cables of the storage battery. Instructions are resulted in Section Replacement of the storage battery.
Models with a lateral pillow of safety: Disunite a socket of a pillow of safety.
|
Take out a back (1) upward from collars (2) fastenings (3).
|
|
|
Installation
|
|
Installation is carried out in sequence, return to removal.
|
|
During joining of the storage battery in salon there should not be people. |
Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (), and then a negative cable (-) to a battery accumulator room.
|
|
Lateral pillow of a back seat
Removal
|
|
|
|
At a detachment of cables of system of a pillow of safety necessarily observe security measures at the reference with a safety pillow, address to Section the General data and security measures. |
|
To exclude operation a pillow of safety of a head, switch off ignition and disconnect at first negative (-), and then positive accumulator room cables
Remove a back seat.
|
Turn out the screw (6).
|
|
Models with a lateral pillow of safety: Press a lock lath and disunite a socket of a pillow of safety.
Turn away a nut (4), turn out анкерный a bolt (5) and remove a lateral pillow (1). (2) - тарельчатая a washer, (3) – a washer.
|
|
Installation
|
|
Installation is carried out in sequence, return to removal. Thus adjust анкерный a bolt and tighten a nut the moment 55Нм. The screw (6) tighten the moment 10Нм.
|
|
During joining of the storage battery in salon there should not be people. |
Models with a lateral pillow of safety: Remove изоляционную a tape from the negative plug of the storage battery, attach at first positive (), and then a negative cable (-) to a battery accumulator room.
If after inclusion of ignition the signalling device of a pillow of safety on a control panel does not die away, it is necessary to consider the information from memory of malfunctions on HUNDRED.
|
|
|
|
