Audi A4, S4
Introduction
Controls and receptions of safe operation
Current leaving and service
The engine
Systems of cooling, heating and the air conditioner
Power supply systems, release and decrease in toxicity of the fulfilled gases
Systems of an electric equipment of the engine
Manual box of a gear change
Automatic transmission
Coupling, power shafts and differential
Brake system
Suspension bracket and steering
- Body
   The general data and security measures at carrying out кузовных works
   Cleaning and leaving
   Repair of insignificant damages кузовных panels
   Repair of considerable damages of a body
   - The external equipment
      Installation of the forward panel in position for maintenance service
      Removal and installation of a cover of a water modular compartment
      Removal and installation of a forward bumper
      Removal and installation локера a back wing
      Removal and installation локера a forward wing
      Removal and installation of a forward wing
      Removal and installation of a back bumper
      Removal and cowl installation/adjustment
      Removal and installation of a cable of a drive of a cowl
      Removal and installation of a clamp of the lock
      Removal and installation of facing of a forward door
      Removal and installation of facing of a back door
      Removal and door installation
      Door adjustment
      Removal and installation of a frame of a window of a forward door
      Removal and installation стеклоподъёмника
      Removal and installation of the electric motor of a drive стеклоподъёмника
      Removal and installation of the lock of a door
      Removal and installation of the handle of a door
      Removal and installation of the cylinder of the lock of a door
      Removal and installation of facing of a cover of a luggage carrier
      Removal, installation and adjustment of a cover of a luggage carrier
      Removal and installation of the lock of a luggage carrier
      Removal and installation of facing of a door of a back (Versatile person)
      Removal and installation of a door of a back (Versatile person)
      Removal and installation of the lock of a door of a back (Versatile person)
      Removal and installation of an external mirror
      Removal and installation молдингов
      Removal, installation and check сдвижной roof panels
      Removal and overlay installation сдвижной roof panels
      Check and starting position adjustment сдвижной roof panels
      Removal and sealant installation сдвижной panels
      Replacement of elastic bands of brushes of a screen wiper
      Removal and jet installation ??????????????? a windscreen
      Removal and installation of a jet of a washer of back glass
      Removal and installation of the lever of a cleaner of a windscreen
      Removal and installation of the lever of a cleaner of back glass
      Removal and installation of jets фароомывателя
      Adjustment of levers of a screen wiper
    The salon equipment
Onboard electric equipment




Removal and installation of a door of a back (Versatile person)

Removal

 PERFORMANCE ORDER

    Disconnect a negative cable (-) the storage battery.

Observe instructions Replacement of the storage battery Has undressed.

    Remove facing of a door of a back, address to Section Removal and installation of facing of a door of a back (Versatile person). Disunite sockets of heating of back glass and a screen wiper, and also the uniform lock. Disconnect a hose of a washer of back glass.

For simplification of installation it is necessary will fix on the ends of a wire a cord which after вытягивания wires remains in a cover.

Necessarily ask the assistant to take a back door before removing газонаполненный an emphasis. Otherwise the door can fall, since it cannot keep only for the account of one демпфера.

    Disconnect above газонаполненный an emphasis (1). For this purpose raise a screw-driver a lock spring (3) a little and remove an emphasis from a spherical pin (2). The second emphasis remove in the same way.
    Remove covers of loops and directing for a cable, located at a loop. For the subsequent installation: Mark with a felt-tip pen position of loops of a door of a back.
    Turn out screws (arrows on an accompanying illustration) at the left and on the right from a back door.
    Remove a door by means of the assistant.

Installation

 PERFORMANCE ORDER

    Establish a door by means of the assistant on loops. An old door expose thus on earlier executed labels. Screw screws at the left and on the right. Establish газонаполненный an emphasis on a spherical support and insert a lock ring. In the same way establish the second emphasis. Ослабьте a lock clamp, close a door and adjust it in relation to adjoining elements. Tighten screws the moment 21Нм. The further installation is carried out in sequence, return to removal. Attach a negative cable (-) the storage battery.

Observe instructions Replacement of the storage battery Has undressed.

Back door: Check/adjustment

 PERFORMANCE ORDER

    Check up backlashes in interface of a door of a back to adjoining elements of a body. Backlashes on all perimetre should be uniform. The door should coincide with lateral elements of a back part of a body. Over a roof the door should not act more than 0.5 mm.
    Turn away a nut (1) and (3) so that the clamp of the lock (2) could be displaced.

The pad (on an accompanying illustration) on a clamp shows the marksman back.

    Uncover (1) on the left and right emphasis, and establish the adjusting screw (2), having turned it counter-clockwise, in position 0.
    Close a door and press it on 2 mm into a body. Open a door and tighten nuts the moment 21Нм. The door should be closed on the lock easily and not to have backlash. Check up backlashes.
    Adjust position of the left and right emphasis so that the closed door had no backlash. For this purpose put on an emphasis of a few plasticine and close a door. On a plasticine print it is possible to judge, whether the door is correctly adjusted
    Establish on a cover emphasis.