Instructions: Removal and installation on models the Sedan is carried out similarly. Unlike models the Versatile person there are no basic and sealing laths (7), (9), and also a support (14). 1 — Two bolts 2 — Loker of a wing 3 — the Nut 4 — the Nut 5 — Directing 6 — Six clips 7 — the Basic lath 8 — the Bolt
9 — the Sealing lath. It is inserted into a bumper 10 — the Decorative lath. It is inserted into a bumper 11 — the Lateral sealing lath. It is inserted into a bumper 12 — the Bumper 13 — Two bolts 14 — the Support. At installation of a new bumper it should be replaced. 15 — the Shock lath Instructions: the Shock lath is fixed on a back bumper by a bilateral sticky tape. Thereof at removal it collapses.
The versatile person
Removal
PERFORMANCE ORDER
Disconnect a negative cable (-) the storage battery.
Some operations are carried out as with left, and справой the car parties. Their description is given only concerning one party.
Remove lateral facing in a cargo compartment, address to Section Removal and installation of facings (Versatile person).
Disunite a socket of a loudspeaker behind lateral facing and disconnect a loudspeaker together with the amplifier.
Disunite a socket of parking sensor controls at the management block under a back lantern.
Turn away a nut (3) and nuts (4) in a cargo compartment.
Turn out bolts (13).
Disconnect локер a wing in a back part.
Turn out a bolt (1) at directing (5) and remove a lateral part of a bumper.
By means of the assistant pull back a bumper and remove it.
Installation
PERFORMANCE ORDER
Installation is carried out in sequence, return to removal.
At installation of a new bumper establish from below a new support (14). Then release a support, having pulled for a thread. Thus the support unloads and holds a bumper in relation to a cross-beam.
The support is released when the bumper is completely established.
