Check and starting position adjustment сдвижной roof panels Electric motor installation сдвижной panels in a starting position
|
|
Close сдвижную the panel.
Remove a forward ceiling plafond, address to Section Removal and installation of plafonds of internal illumination.
Turn away screws of fastening and remove the electric motor сдвижной panels.
Electric wires of the electric motor do not disconnect.
Include ignition.
Establish the rotary switch position the Roof it is closed. Thus the electric motor works automatically and stops in zero position.
In this position establish the electric motor at the closed roof and fix it.
Establish a forward plafond.
|
|
Starting position check кулисной the directing
|
|
|
|
The starting position can be checked up by means of a pocket mirror and a pocket lantern at established сдвижной panels. |
|
Remove lateral overlays at the left and on the right, address to corresponding Section.
|
Open and again close сдвижную the panel.
|
Shift the ceiling panel completely back.
|
Put on сдвижную the panel a pocket mirror and check up a starting position. At correct installation a rectangular groove in the promotion mechanism кулисной directing (1) should coincide with a groove (an arrow on an accompanying illustration). Otherwise make adjustment.
|
|
|
Installation of a directing side scene in a starting position
|
|
Remove сдвижную the panel.
Remove the panel electric motor.
Remove lateral overlays, address to corresponding Section.
Displace кулисные directing (1) from both parties from back position forward.
Establish a rectangular groove in the promotion mechanism кулисной directing (1) so that it coincided with a groove (marksman) on the directing tyre (2) panels of a ceiling. Thus the starting position of a directing side scene is established.
Establish the electric motor сдвижной panels in a starting position.
Establish lateral overlays.
|
|
|
